Maico MB 11 Classic, Руководство по эксплуатации

Страница: 29 / 72

Operation Manual MB 11 Classic
8100498-4_OM_MB11_Classic_3.18_EN_16a.docx 27 01/16
“Tracking Path” – Allows the user to define the desired data path for saving
of the automatically created tracking file.
The Test Settings area allows the user to enable (checked) or disable
(unchecked) the following features that occur during a measurement:
“Display EEG (Screening)” – sets the EEG view as the default when
enabled; otherwise the quality indicator bar is displayed above the
measurement graphic during data collection.
“Beep after test” – enables an audible “beep” that occurs when a
measurement is complete. The quality and audibility of the beep may be
affected by the specific PC that is used.
“Automatically close test distortion message” – enabling of this control
causes a pop up message regarding test distortion to disappear after 7
seconds. When disabled, the user must manually close this message that
occurs immediately after an impedance test when cyclical noise is detected
in the EEG signal.
The MB 11 Classic area allows the user to set preferences related to testing
when the hardware being used is the MB 11 Classic rather than the
BERAphone. This control will only show up in the dialog if an MB 11 Classic
is attached to the PC when the software is launched.
“Binaural test allowed” – Enabling this setting allows access to a
“binaural” test option during data collection with the MB 11 Classic. If this
control is disabled, then only the right ear or left ear can be selected and
only a monaural test can be performed.
The Patient ID Settings area allows the user to set preferences regarding
the handling of the patient ID.
“Disable” – disables the field for the patient ID. Control is not available
when Tracking is enabled. Disabling the Patient ID field allows you to collect
and save test data without entering a patient ID. Disabling the patient ID
can make it difficult to differentiate patients with the same name.
“Automatic” – disables the Patient ID field for user entry, but automatically
assigns a random ID number upon entry of a new patient.
“User-entered” – the default setting; requires user to enter an ID for each
patient.
5.4.3 Menu “About”
Click on “ About ” to see product information about the software version
and contact information.