Maico EFR Series, Монтаж и эксплуатация, Страница: 10 / 12

10
● Connect the ducting to the duct fan using
flexible cuffs, e.g. MAICO ELR, in order to
prevent the transmission of vibrations to
the duct system.
● Install an air filter, e.g. MAICO TFE if
operating the unit in a dusty environment.
7. Installation
Installation
As far as possible, install the EFR-
Flatbox such that there is no transfer
of vibrations to the ducting system,
e.g. by using MAICO ELR flexible
cuffs and vibration dampers.

Make sure there is a level surface at the
installation location.
 Position the mounting bracket and mark
the locations of the four holes that have
to be drilled.
 Drill the holes and insert fixing plugs.
WARNING
Danger of injury caused by
inadequate mounting of the
EFR Flatbox.
 Make sure you use mounting
material, which is sized for the
purpose.
 Bolt or screw the mounting bracket to the
wall/ceiling/bracket using suitable mounting
material to be supplied by the customer.
 Insert the EFR Flatbox in the cut-outs in the
mounting bracket and fix it in place. Tighten
both knurled thumb screws.

Install suitable folded spiral-seams duct.
 Make sure that the ducting is not twisted
during installation.
Electrical connection
DANGER
Danger to life from electric
shock
 Switch the mains fuse off.
 Position a warning notice to
avoid the unit being
accidentally switched back on.
CAUTION
Danger of short-circuits
through incorrect feeding of
the power cable into the
terminal box.
 Feed the power cable into the
terminal box correctly.
 Make sure there is tension
relief in the case of a 90°
cable feed. Tension relief to
be supplied by the customer.
The cabling between the power and
the terminal box must be permanent.
 Remove the terminal box cover.
 Separate out one of the two knockout
points on the wall of the terminal box (see
arrows).
 Make sure there is tension relief in the case
of a 90° cable feed.
 Strip the insulation off the power cable and
feed it into the terminal box.
CAUTION
Danger of short-circuits
caused by damp if the power
cable is not inserted correctly.
 Insert the power cable
correctly.
 Connect plug [10]. See printed label on the
plug and the wiring diagram on Page 12.
 Locate plug [10] on the plug connection.
 Lay the power cable. See wiring diagram in
the terminal box.
i
i
GB