Maico ECA 100 ipro RC, Монтаж и эксплуатация, Страница: 30 / 50

EN
28
Press and hold the teach-in button [10] at 3.
the fan (>1 second), until the LED on the
slave fan lights up briefly
once .
> The teach-in telegram is sent. If
teaching-in is completed successfully,
the button LED lights up
once for
approx. 1.5 seconds. If transfer was
faulty, the button LED flashes briefly
3
times . If the teach-in process fails, the
LED on the slave fan flashes briefly
three times . The process has to be
repeated.
9.6 Deleting transmitters
Deleting an individual transmitter
If there is a transmitter that is faulty or
that can no longer be identified, it is
possible that all transmitters must be
deleted. System components than
have to be taught-in again. This is
recommended if a transmitter was lost
or is faulty.
In order to delete the required transmitter, 1.
the transmitter teach-in process (RLS RC,
radio switch or window contact) has to be
repeated (

Chapter 9.5).
Deleting all transmitters
Activate teach-in mode at the fan. 1.
> The LED flashes, teach-in mode is
activated.
Press the teach-in button [10] briefly 2.
twice .
> LED flashes briefly twice and then goes
out.
Press and hold the teach-in button [10] on 3.
the fan (>1 second), until the LED on the
fan lights up briefly once.
> All transmitters that have been set up,
are now deleted. The fan is again in its
initial state.
9.7 Setting up the fan as a signal
amplifier
(Repeater)
The radio electronics in the fan can also be
used as a signal amplifier. In this case, the
fan that is set up this way works additionally
as a signal amplifier. EnOcean telegrams are
received and forwarded in parallel to the
running application.
This can be necessary for example, with
applications in single-family houses that are
completely automated with EnOcean products.
Settings values
● Off
● Level 1 = Original telegrams are amplified
● Level 2 = Original telegrams and telegrams
that have already been amplified are
amplified
Setting up the fan as a signal amplifier
Activate teach-in mode at the receiver 1.
(fan).
> The LED flashes, the teach-in mode is
activated.
Press the teach-in button [10] briefly three 2.
times .
> The LED lights up briefly and then
flashes briefly three times .
Press the teach-in button [10] x times 3.
for repeater mode:
Repeater off once LED flashes once
Repeater Level 1 twice LED flashes twice
Repeater level 2 three times LED flashes
three times
Press and hold the teach-in button [10] on 4.
the fan (>5 seconds), until the LED on the
fan lights up briefly
once for approx. 1
second.
> The setting is saved.
i