Maico easyTymp, Руководство по эксплуатации

Страница: 19 / 65

Operation Manual easyTymp
8111254 Rev. 7.0 15 02/16
4.3 System Installation
4.3.1 Hardware Installation
4.3.1.1 Installing the Cradle
Figure 1
1 = USB in;
2 = USB out;
3 = USB out;
4 = USB out
5 = Power;
6 = Follow the
instructions for use
Put the enclosed mains cable into the power connection socket
#
5 and the mains plug
into a power socket.
4.3.1.2 Cradle Indication Lights
Depending on the version (with or without printer) the cradle has up to three indication
lights (Figure 2).
Figure 2

easyTymp LED shows solid blue when it is placed
inside the cradle. The battery will be charged
automatically and will be fully charged after
approximately three hours. The current battery
state of charge may be seen on the easyTymp
display.

Battery LED shows solid blue when the spare
battery in the cradle is fully charged. The LED will
flash while the battery is charging.

Printer LED is red when a printer problem occurs.
4.3.1.3 Installing Paper in the Thermal Printer
Figure 3
Step 1
– Push button to open the printer cover (Figure 3).