Mahindra ALTURAS G4 2019, Руководство пользователя

Страница: 119 / 340

© Copyright Mahindra and Mahindra Ltd. 092018
4-29
4.11.3 Other Maintenance
After driving on a calcium chloride (salt) sprayed road, wash the
bottom of your vehicle as soon as possible to avoid any rust. When
parking on a snow-covered road, the brake system may begin to
have some ice on it. The ice will decrease your vehicle’s braking
ability. If this happens, drive at a low speed and use the brake
frequently to remove the ice. After regaining the braking ability,
drive your vehicle at a normal speed.
• When there is ice on the wiper blades, turning on the wiper
switch may put an extra burden on the wiper motor and
damage it. Avoid using the wipers when ice is on the blades
• When driving on a snow-covered road, a large amount of
snow may build up under each wheelhouse. This buildup
prevents the steering wheel from moving freely. Therefore,
remove the snow buildup frequently
4.11.4 Diesel Fuel in Winter
On an extremely cold day, paraffin, one of the chemicals in diesel
fuel, may separate from the diesel fuel. This separation makes
starting the engine difficult. Therefore, to ensure an easy start on a
cold day, park your vehicle inside of a garage. If possible, fill up the
fuel tank after each driving to prevent ice from forming inside of the
fuel system.
• Change engine oil and the fuel filter as scheduled.
Contaminated engine oil will lose its viscosity, clog the fuel
filter and oil filter and cause difficulties starting the engine
• Do not add any additives other than the genuine fuel for
better startability at owner’s disposal. The additive may
decrease the lubricating ability of the internal fuel system;
the additive may have a different flashing point. This will
damage the fuel system or produce an excessive exhaust
fume
4.12 Turbocharger System
Insufficient oil supply to the bearing assembly in turbocharger may
cause the turbocharger to seize. Therefore, the following cares are
necessary to prevent the seizure:
• Use only the specified engine oil and observe inspection and
replacement intervals
• Operate the engine over the idling speed only after normal
engine
oil pressure has been established. Forcing the
turbocharger to operate before the bearings are adequately
lubricated creates unnecessary friction
• After starting the engine, let it run for approx. 2 minutes at idle
speed (Avoid acceleration or driving off the vehicle)
STARTING THE ENGINE AND DRIVING THE VEHICLE