MAHA LPS 3000, Руководство по эксплуатации, Страница: 12 / 115

12
BA052301-en
•
Load capacity reduction with:
- non-symmetric (unbalanced) load
- usage in tightening process only with permissible end loop reinforcement
•
Shall not be used in lye.
•
Usage forbidden when there are mechanical damages, deformation or damages to any safe-
ty features.
Inspection and maintenance after one year only by skilled technicians
Sling Chain
Sling chain (two parts) NL 1 m, with KHS-hooks. Load capacity 2000 kg with 45 … 60 ° inclination
angle.
•
Usage only by authorized, trained personnel.
•
Inspect the sling chain for damage of any kind and other safety application before commis-
sioning; do not use if there is mechanical damage, deformations, stretching of the chain or
an individual link, or reduction in the thickness.
•
Do not exceed permissible load capacity.
•
Use only suitable tie down positions.
•
Use only sling chains with readable marking tag.
•
Do not knot or twist the chain and do not place over sharp edges.
•
Operating temperature: -40 … +200 °C
•
Load capacity reduction when there is:
- non-symmetric (unbalanced) load
- usage in tightening process.
•
Shall not be used in acid or lye.
•
Usage forbidden when there is mechanical damage, deformation or damage to safety fea-
tures.
•
Do not load the hooks at the tip.
•
Inspection and maintenance only by trained technicians after one year, and every 3 years a
special chain check for fracture detection.
1.12 Safety Features
The safety features must be checked regularly by an authorized service technician. Pay
attention to statutory requirements. The dyno shall not be operated with defective safety
features.
Lockable Main Switch
Serves as a normal On and Off switch and as an emergency switch. The switch can be
protected against unauthorized usage by locking with a padlock.
Pit Safety (optional)
Light barrier or infrared movement sensor. Issues audible and visual signals in the event that
persons are in the working pit.
Warning and Information Labels
Warning and information labels are attached to the dyno. The labels shall not be changed or
removed. Defective warning and information labels must be replaced.
1.13 Accessories
The equipment shall be operated only with accessories which have been approved or permitted
by MAHA.