MAHA CONNECT Series, Оригинальная инструкция по эксплуатации

Страница: 113 / 138

113
BA023001-en
11.3 C_MSA (MAHA universal analogue display)
11.3.1 Description
The C_MSA (CONNECT_MAHA simultaneous display) is used to display measured
values generated by a brake tester.
The LEDs are used for user guidance and indicate whether the display is in operation
and connected, and whether the pointers refer to the small or the large measuring
range.
Simultaneous displays are used in workshops or test centres, especially in the truck
sector where vehicles are so long that the driver has already passed the primary
display while other axles are to be tested.
Some workshops operate the test bench outdoors, here the robustness of the
analogue display with regard to humidity and temperature is required as well as the
high contrast of the display (e.g. in sunlight) compared to a PC/TV monitor, which is
usually the primary display.
The data connection of the C_MSA to the brake tester can be established either via a
network cable or via a WiFi connection.
Inside the C_MSA is a control board that controls three stepper motors and three LEDs.
The board is equipped with interfaces for the power supply (wide range input
12...24 V DC / < 1 A current consumption), an RJ45 network socket and an SMA
connector for the WiFi antenna.
Power is supplied via a commercially available plug-in power supply unit with hollow
plug (5.5/2.1 mm).
MAHA universal analogue display