Magura TS6, Руководство пользователя

Страница: 23 / 34

I
NSTALLATION
23
ENGLISH
T
AKING THE
e
LECT
INTO OPERATION
Charging the eLECT rechargeable battery
L
Charge your eLECT rechargeable battery before taking it into operation
for the first time.
Danger of accident due to improper accessories.
h
When charging the rechargeable battery, exclusively use intact micro-
USB mains adapters that are also suitable for mobile smartphones.
) Remove the eLECT cover by unscrewing it counter-clockwise
[
L1
]
or open the cap (rear shock)
[
L2
]
.
) Switch off the eLECT (OFF)
[
L1
] [
L2
]
.
)
Connect the micro-USB plug to the charging socket.
) Connect the mains adapter to the mains.
Î
LED ( 1 ) flashes slowly (1 s).
Î
Rechargeable battery is being charged (approx. 3 h).
Î
LED (
1
) is red.
Î
Rechargeable battery is charged.
L Your eLECT rechargeable battery is protected against overcharging.
Avoid unnecessary electricity consumption by disconnecting the mains
adapter and micro-USB cable from the mains after charging.
) Disconnect the micro-USB plug from the charging socket.
Î LED goes out.
) Switch on the eLECT (ON)
[
K1
] [
K2
]
.
) Replace the cover on the eLECT by screwing it on clockwise
or close the cap (rear shock).
Installing the eLECT remote control
L Only eLECT units with a printed ANT+ symbol
[
M1
]
can be remotely
controlled – and this requires the corresponding ANT+ eLECT remote
control.
L The eLECT remote control makes it possible to change over from auto-
matic to manual mode. If you operate the eLECT exclusively in auto-
matic mode, you do not need to install the remote control.
The MAGURA eLECT rear shock does not have the automatic mode of
your MAGURA suspension fork - the eLECT remote control can be used
to switch the compression damper between
OPEN and LOCKOUT
– see the
U
SER
I
NSTRUCTIONS
– TS RL • TS RC
.
Danger of accident due to faulty installation work.
h Make sure that the eLECT remote control cannot interfere with brake
and gear shift actuation and function in any lever position.
L The eLECT remote control ( 1 )
[
M2
]
is generally mounted on the right
– with the buttons facing the handlebar.
It can also be mounted on the left-hand side – or with the buttons
facing the handlebar stem – if desired. In this case the arrow keys can
be switched around – see
Assigning the arrow keys on the eLECT remote con-
trol
, page 24.
) Define the position of the eLECT remote control on the handlebar.
Î Brake and gear shift actuation and function are not allowed to be
impaired by the eLECT remote control.
) Place the rubber half shell ( 2 ) between the handlebar and the remote
control.
) Fix the eLECT remote control to the handlebar with rubber ring ( 3 ) .