MAGUIRE Weigh Scale Blender 4088, Установка, эксплуатация и обслуживание

Страница: 97 / 149

97
Backup, Restore, Factory Reset
Locations of stored Blender settings and their purpose
There are 3 memory areas where Blender settings are stored. These options are accessible
by pressing Setup, System Configuration, Resets, User Settings.
1. Restore User Settings - The current settings in use. When you make parameter
changes and/or enable features, the changes (if any) are recorded into the user-settings
when you exit OPTIONS mode. When changes are made to User Settings, the
changes are stored in EEPROM memory so that they are not lost when the Blender is
powered off.
2. Save User Settings
– The area in memory where User Settings are backed up into
when the “Save User Settings” function is used. If User Setting were never backed up
using “Save User Settings” function then Factory default settings reside in this memory
location. If they wer
e previously backed up, User Settings can be restored into “User
Settings” using the Restore User Settings function.
3. Load Factory Settings - The area in memory that holds the Blender's factory default
settings. The Factory Default Settings are hard-coded default settings for each model.
Factory Default Setting can be restored using the “Load Factory Settings” function.
Restore Factory Defaults is located under Setup, System Configuration, Resets.