MAGUIRE Ultra-600, Установка, эксплуатация и обслуживание

Страница: 87 / 109

Maguire Products, Inc.
Rev. June 11, 2020
– ULTRA-600 Touchscreen
87
ULTRA By Maguire

- Ultra Low Energy Dryer
Receiver Configuration Fields
Blowback - Blowback is a pulse of air to clear the filter. Blowback has two configuration fields. Skip cycle defines the
number of cycles the receiver will skip between blowback pulses. Default for Skip Cycle is 3. Setting Skip Cycle to 0
(zero) will pulse every time. Time Interval is a multiplication factor of 400ms to pressurize the charge canister. Default
Time Interval is 1 (1=400ms).
Load Time - The time in seconds that the receiver will load.
Load Retry - The number of times the receiver will try to successfully load material and satisfy the sensor. Exceeding
this retry count will cause the receiver to alarm.
Dump Time - The time in seconds that the receiver will remain open during the dump cycle.
Pump Assignment - The ID number of the pump that this receiver is assigned to.
Pulse Time - Pulsed on-time in tenths of a second that the Bridge Breaker output (output 6) will pulse during Dump
Time. (see Flexbus Receiver Card Wiring Diagram, Output 6).
Purge Time - The time in seconds that the purge valve will open to purge the convey line. (Purge time follows Load
time).
Priority - Sets the order of importance of the receivers. Setting a receiver to level 1 sets to
the highest priority, while setting to level 5 sets to the lowest priority. Higher priority
receivers receive material first while lower priority receivers receive material later.
Purge - This symbol represents the purge valve. When purging, the symbol will show a blue arrow.
The Receiver's label and defaults can be reset by touching the large receiver image in the center of the screen.