MAGUIRE Ultra-600, Установка, эксплуатация и обслуживание

Страница: 14 / 109

Maguire Products, Inc.
Rev. June 11, 2020
– ULTRA-600 Touchscreen
14
ULTRA By Maguire

- Ultra Low Energy Dryer
Dryer External Connections
Heating Hopper Air Lines/RTD/Sensor
Cables
On top of the machine, next to the heating
hopper, there are a series of air lines and
cables that need to be connected.
There is a total of 3 air lines; two are which are
for the vacuum chamber upper slide gate
(red), and one to supply cooling air to the
heating hopper level sensor (yellow).
There are 2 RTD cables that need to be
connected. The orange connector indicates
T1, which is the inlet temperature going into
the heater hopper. The black connector
signifies T3, which is the temperature at the
top of the heating hopper.
Connect the level sensor cable to the
corresponding CPC connection on the top of
the machine.
If the air lines are not protruding through the
top of the machine, through the grommets, the
top panel will need to be removed. The air
lines will have to be located and fed through
the grommets on the top metal panel. Re-
install the top panel.
Install Heating Hopper Level Sensor and
Bracket
Install the heating hopper bracket and level
sensor onto the adaptor plate located on top of
the heating hopper (as shown). Locate the
sensor cable that exits the top of the ULTRA
Heating Hopper and attach the sensor cable to
the sensor.