Magtrol TORQUE 10, Руководство пользователя, Страница: 31 / 54

TORQUE 10 TEST FUNCTION
www.magtrol.com 23
7. TEST FUNCTION
This example shows the activation of both channels TS 100 Series connected in USB mode.
The LED next to the Tare buttons indicate the status of the Tare value for each channel.
Figure 27 Test button
The parameters are refreshed each second when the test not running
CONTROL FUNCTION
Sampling Rate [Hz]
The frequency at which a data point will be stored.
The maximum frequency is:
TS =
500Hz (10k Samples for 1 second in HS)
3411 = 50Hz (488 in HS)
3410 = 20Hz
SET Tare CH1/CH2 Set the current torque to the Tare value. The tare is not saved.
SAVE Tare CH1/CH2
Set the current torque to the Tare value. The tare is saved inside
the TS
RST Tare CH1/CH2 Remove the Tare value.
RST Angle CH1/CH2 Reset Angle to zero before Run Test
BITE CH1/CH2 Set the Bite function for about 10sec.
Graph/Digital
Swap between graphical or numeric display. For long term test,
it is recommended to set the Digital display
➔ memory
management
Y Axis 1 Select the parameter to show on Y axis 1
Y Axis 2 Select the parameter to show on Y axis 2
Auto Y axis Enables auto-scaling of the Y-axis parameter.
Auto X axis Enables auto-scaling of the X-axis parameter.
Run Start the test.
Stop Stop the test.