MT-95 RS-232 HiCo/LoCo Encoder/Reader
22
Press
E
and if there is data in the buffer, the display will be:
Encoding data on tracks 1 2 3
Insert the card for encoding
(Auto)
(Auto)
is a reminder that the setup is for auto mode. Immediately after the card is
encoded, it is read and verified with the data entered into the buffer from the keyboard. If
the encode data and read data compare, the encoder will indicate a good encode by
displaying:
*** CARD ENCODED CORRECTLY ***
Remove the card
If the card did not encode correctly, the display may show:
**Did not encode properly. Try again.**
-> Slide card right when ready ->
or if the card is HiCo:
This may be a HiCo card. Try again.
-> Slide card right when ready ->
Swipe as required.
Fixed Format Encoding
From the Main Menu select
E)ncode
, or press Esc until the following menu appears:
Select encoding type
Esc=exit
1) Free Format
2)Fixed Format
Fixed Format Encoding permits the user to create a format card from which a sequence of cards
can be easily encoded. To become familiar with the Fixed Format, follow these steps:
1.
From the Select encoding type menu, press
2
for Fixed Format options:
Select an operation
Esc=exit
E)ncode cards
C)reate Format Card
If a Format Card exists, go to step 2. If a Format Card does not exist, go to Create
Format Card, below.
Содержание MT-95
