Magtek MT-95, Инструкция по установке и эксплуатации

Страница: 23 / 54

15
SECTION 3. STANDALONE OPERATION
This section describes card reading, copying, and encoding which are basic to operating the
Encoder with a keyboard. After the self test and version displays, the main menu will appear:
Select a card operation
R)ead C)opy E)ncode S)etup
Ensure the Setup operation, as described in Section 2, is completed before proceeding.
CARD READING AND ENCODING FUNDAMENTALS
To read a card, either just insert a card for reading or select
R
from the main menu shown above,
and the following will appear:
Insert card for reading
or press Esc to exit
Hold the card firmly in the middle with the magnetic stripe down (toward the bottom of the
encoder). Insert the card into either end of the encoder slot. The display will indicate the
direction the card should be moved; for example, if the card is inserted in the right side:
<-- Slide card left when ready <--
After the card has been moved to the other end of the slot (this is called “swiping the card”), the
display will indicate whether the card was successfully read or not. If the read was bad, the card
must be swiped again to reread the data. The card may be swiped as often as needed to get a
good read. There is no limit on the number of retries.
If a card is to be encoded, there must be information in the buffer for each track to be encoded.
Select
E
from the main menu, then select
1) Free Format
then
E
, and if there is no data in
the buffer, the following will appear:
Select an operation Esc=exit
No data to encode.
To encode, either read a card as described above, or manually enter data with a keyboard. Then
select
E
from the main menu. Then Select
1) Free Format
from the following:
Select encoding type Esc=exit
1) Free Format 2)Fixed Format