Magtek MT-95, Инструкция по установке и эксплуатации

Страница: 14 / 54

MT-95 RS-232 HiCo/LoCo Encoder/Reader
6
1. The rear panel of the encoder is shown in Figure 2-1. If a keyboard is to be used, plug the
cord from the keyboard to the rear panel of the encoder marked “KEYBOARD” as shown
in Figure 2-2, and go to step 2.
or
If a PC is to be used, select either the 9- or 25-pin cable and plug the 9-pin connector on
the encoder rear panel marked “MODEM” to the 9- or 25-pin connector on the PC as
shown in Figure 2-3.
2.
Plug the female end of the power cord into the rear panel of the encoder marked
“POWER”. Plug the other end into a power source.
3.
Press “
I
” on the switch marked “ON” .
4.
Ensure the proper Communication Port is selected on the PC, if applicable.
5.
The default communication parameters on the encoder are shown in Table 2-1. The
parameters may be changed as described in Setup. Ensure the parameters on the PC are
the same as those on the encoder.
Figure 2-1. Rear Panel
Connect
to PC
or 4778
PIN-Pad