3 - Operation
iDynamo 5 and iDynamo 5 (Gen II)| Secure Card Reader Authenticator | Installation and Operation Manual
Page 20 of 33 (
D99875473-120
)
3.1.2
How to Set Up Pass-Through Charging
iDynamo’s pass-through USB port only supports charging the iOS host. It does not
support synchronizing data. To synchronize the iOS host with a computer, you must
disconnect iDynamo and connect the iOS host directly to the computer.
iDynamo is equipped with a pass-through USB port which allows the connected iOS host to continue
charging while iDynamo is connected.
To set up pass-through charging, follow these steps:
1)
Disconnect iDynamo from the iOS host.
2)
Verify the charging source works properly without iDynamo: Connect the iOS host directly to the
power source using the iOS host’s original cable. The power source may be a computer’s high-power
USB port (2A @ 5V) or an Apple-supplied or third-party charger designed for the iOS host.
3)
Make sure the iOS host charges correctly.
4)
Disconnect the charging cable from the iOS host.
5)
Connect iDynamo to the iOS host. See section
6)
Connect the charging cable to iDynamo’s pass-through USB port.
