5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 232 of 356 (
D99875607-91
)
Figure 5-96 - Foil Sensor Cable (TOP VIEW FROM FRONT)
6)
Disconnect the exit transport magnetic stripe reader (MSR) cable as follows:
a)
On the left side of the exit transport, find the connector between the cable and the MSR head and
disconnect it. Carefully note which connector you are disconnecting the cable from.
b)
Pull the exit transport slightly forward (or out) and cut the cable tie that holds the MSR cable to
the main cable on the bottom back of the exit transport’s base.
