5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 101 of 356 (
D99875607-91
)
5.6.2
Remove
To remove the right latch assembly, follow these steps:
1)
Prepare the device for replacing parts by following the steps in section
Device for Removing / Re-installing Modules
. At the end, the device should be powered down with
all external cables safely disconnected and the hopper shuttle parked near the front of the device.
2)
Unlock the top access door (see
ExpressCard 2000 Installation and Operation Manual
).
3)
Open the top access door.
4)
Remove all the card stock hoppers and set them aside in a secure location, or give them to the
customer for secure temporary storage, as shown in
5)
Unclip the cable from the three cable clips attaching it to the case.
6)
Trace the cable from the latch solenoid to its connector in the front right corner of the case, just below
the hopper plate. Pull gently upward on the cable to bring its connector within easy reach.
