Magtek EXPRESSCARD 1000, Руководство по обслуживанию оборудования

Страница: 79 / 194

ExpressCard 1000 Service Manual
72
Setting the Print TOF
Step Procedure
1. Choose
Menu> Printer> Menu
from the LCD display,
Print Test Image
and the ribbon
type to print a test card.
2. Select
Setup Printer
,
Print Settings
and
Print TOF
.
3. Record the Print TOF value on the test card (you just printed).
4. Examine the test card. (
Note:
When centered properly, the Alignment Arrows should
appear just at the edge of the card's leading edge. If your test card does not look like
the sample shown below, go to
Step
5 to adjust the Print TOF.)
5. Decrease the Print TOF value to move the printed image more toward the leading edge
of the card.
OR
Increase the Print TOF value to move the printed image more toward
the trailing edge of the card.
•
The numbers being entered for the settings are in ½ pixels.
•
The number of pixels is equal to the measurement in inches times 600 or the
measurement in mm times 23.6. (For example, 0.100 inches or 2.54mm equals 60
increments on the LCD.)
6. Press
DONE
to save the value and print another test card. Press
YES
when asked to
save the change.
7. Repeat
Steps
1 to 6 until the test image is correctly positioned as shown above.