6 - Operation
DynaFlex II| Product Family | Installation and Operation Manual
Page 39 of 78 (D998200554-10)
Figure 6-6 – SoftAP Mode screen
6.5
About Sounds
DynaFlex II products have a beeper (audible signal) that provides feedback to operators and cardholders
about the internal state of the device:
•
The device sounds one short beep after it has successfully read a contactless tap, and the cardholder
can safely remove the card or device from the contactless landing zone.
•
The device emits short beeps continuously when a transaction is complete, but the card is still present
in the insertion slot.
•
The device emits two beeps when reading a card or contactless payment device to indicate a read
error occurred.
•
The device sounds two beeps when an operator cancels a pending EMV transaction.
The device provides an internal setting the host can use to adjust the global system volume. The device
does not provide an interface to change the volume setting directly via buttons or the touchscreen. If the
device is too quiet or too loud:
•
Make sure the device is ordered from the manufacturer with the desired volume setting.
•
Check to see whether the host software you are using provides a feature to check and/or adjust the
volume setting.
•
If the host software does not provide that feature, request help from the development team that built
the host software to check / change the volume setting. For details, see
D998200383 DYNAFLEX
PRODUCTS PROGRAMMER’S MANUAL (COMMANDS)
.
