Magnum MMG75CAN6, Руководство по эксплуатации, Страница: 18 / 52

18
ENGINE MONITORING
Engine information is shown on the Liquid Crystal Display (LCD) window in a toggling manner with the generator
information after the first 60 seconds of operation and then every five seconds thereafter. The Engine Display screen
will show oil pressure, engine coolant temperature, fuel level and battery voltage.
• Oil Pressure: Displays engine oil pressure. The display registers oil pressure between 0-100 psi (10-689
kPa). Normal operating pressure is between 35-80 psi (241-552 kPa).
• Engine Temp: Displays the temperature of the engine’s coolant. If the coolant temperature exceeds the
maximum water temperature of 230°F (110°C) the engine will automatically shut down. Zero will be displayed
until a minimum temperature of 100°F (38°C) is reached.
• Fuel Level: Displays the level of fuel in the tank by percentage (50% = 1/2 tank, 75% = 3/4 tank, etc.). If the
fuel level drops below a programmed low fuel point, usually at 15%, a low fuel warning and optional audio
alarm will be activated. If the fuel level drops below the programmed low fuel limit, usually at five percent,
the engine will automatically shut down.
• Battery Volts: Displays the engine battery voltage. A normal reading is 13-14V on 12 volt systems and 24-
26V on 24 volt systems (with the engine running).
Additional information may be viewed while the unit is in Manual or Auto mode. By pressing the “PAGE SELECT”
button, the operator will select one of the following screens; “Running” screen, “Password” screen, or History screen.
In each of these page selections the operator may press the “
 ” or “  ” buttons on the “DIAGNOSTICS” keypad to
display additional information as follows:
• “Running” screen: The operator may press the “  ” or “  ” buttons on the “DIAGNOSTICS” keypad to
display the “Alarm List” screen, “ECU Alarm List” screen, “Run Hours” screen, “ECU Values” screen, Engine
Display screen and Generator Display screen.