MCC-35
29
5.5.3 Set Outfeed Tray
Set the outfeed tray properly as per the sheet.
5.5.4 Set Crease Data
Press Mode Key
for 6 times to enter Input Crease Data Screen. Input
the value for crease and press Enter to confirm. All crease data is finished,
press Enter twice to take effect. And Screen will go back to Ready Screen.
Note:
If REG. Mark or Slit function is open, turn it off.
5.6 Only Trim Sheet Sides
5.6.1 Place Slitters
Set the slitters referred to
5.4.3
and move the deflecting roller to the trisection
position.
Note:
When only trimming sheet sides, slitter #2 and slitter #3 will be used for
trimming. But they have a limit for trim width
3~6 or over 15 mm
. If side trim is
7~14 mm or less than 3mm paper piece has some risks going into slitters
leading slitter jammed. If side trim is over 15 mm paper piece will not go down
to the waste box just going out with the finished piece.
5.6.2 Set Cut Data
Turn off REG. Mark Function if they were open already. Input cut data referred
to
5.3.3.5
.
Place the tray properly. Then press Start Key to run machine.
5.7 Slide-in Tools
5.7.1 Exchange Slide-in Tools
1. Open the cover and slide out the crease die
2. Take out the perforate die from the tool storage, and put crease die into it.
3. Insert the perforate die into machine and close the side cover.
Содержание MCC-35
