MI-99265 LATHE GU
A
RD
Mounting hardware
required for installation
(not included)
• 4 hex head bolts
• 4 flat washers
• 4 hex nuts
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Select bolts that will
fit 9 mm (3/8”)
mounting holes.
1. Mark the center of the lathe bed (A) and place
the main mounting bracket roughly centered
against the bed to mark required hole placement
(B).
2. Drill 4 pilot holes using a small diameter bit.
Change to a larger bit to match the size of the
bolts used, and drill out the 4 mounting holes in
the lathe bed.
3. Secure the mounting bracket to the lathe bed
using your hardware (not supplied).
4. Using the 4 long bolts with matching nuts and 2
washers per bolt, install the 2 column clamps
to the mounting bracket as shown.
Note: Before drilling through the lathe bed, verify
that non of the holes line-up with the inner ribbing
(re-inforcement) in the bed casting. If so, move hole
placement slightly left or right to avoid drilling into
the ribs.
4x
4x
4x
A
.
B
STEP 1
STEP 2
STEP 3
STEP 4
