29
Multi-machine connection instruction
Multi
machine
Fade In&Out
Switch
“ VGA2 <-
【
OK
】
->
╳
DVI
”, as shown in the left example, the cursor is
located in channel 2, port name is DVI, next to the“
╳
”that no valid signal
under DVI input port; when the cursor is located in the channel 2 (The
cursor on the right), use the“input port selection key”to switch the input
port of channel 1.
Use“LEFT”and“OK”button to make the channel 1 of current processor as
the multi-connection processor’s output; use the“RIGHT”key to enable
the
channel
2
of
current
processor
as
the
multi-connection processor’s output.
Please refer“
Multi-machine fade in fade out
” [
42]
Fade Period
Combination switch sets signal input port switching process can experience
for 0 second to 5 seconds. If set to 0 seconds, then switching process would
be finished instantaneously.
Multi
Connection
Can be set to“single”and“multi machine connection”.
Single
：
Not in the state of the multi-machine connection, that is, not in the
state of the combination switching.
Multi
：
the state of multi machine connection, namely combination
switching state.
Machine ID
Range is 0~7
，
0 representing terminal machine, its previous level machine
Numbers is 1, the level before the previous is 2, and so forth.
Terminal, that is the video processor linking the LED sending card; Please
refer to the“
Multi-machine fade in fade out
”[
42].
Reset
Press“RIGHT”or“OK”to reset the parameter in the multi machine
connection setting function.
Note
：
Multi machine connection hardware setting, please check
Multi-machine fade in fade out
”[
42].