Magni RTH 4.18, Руководство по эксплуатации и обслуживанию, Страница: 42 / 127

42 OPERATION
Configuration of boom
The section at the top of the load control page
contains
information regarding the boom
configuration. The data shown in the graph above and
organised from left to right, top to bottom, are:
- Telescopic boom extension length;
- Height of boom head from the ground;
- Turret rotation graphic indicator;
- Turret rotation numeric indicator;
- Layout for rapid interpretation of information;
- Telescopic boom angle in relation to the horizontal;
- Distance of boom head from turret rotation axis;
- Maximum permitted load for current configuration
of the boom;
- Actual load.
Interactive load chart
The interactive load chart is seen at the centre of the
display. In the top left hand corner a schematic
drawing of the equipment detected is displayed for
rapid identification.
The vehicle control system automatically selects the
appropriate load chart on the basis of the three
parameters measured:
- Type of equipment fitted at the top of the boom,
detected
automatically by means of the
transponder;
- Resting on the ground and percentage extension of
the stabilisers;
- Rotation of the turret.
The position of the load on the chart is identified by
the following icon:
Load position identification icon
The icon moves on the chart in relation to the position
of the boom.
Load percentage
On the right hand side of the page a graduated
indicator displays the ratio, expressed in percentage,
of the load acting on the equipment and the maximum
permitted load.
The load percentage indicator is present in all the
control and command pages.
The load percentage indicator in combination with the
load chart provides complete clear information
regarding the operating conditions of the vehicle.
Controls page
The controls page contains information and controls
regarding the cab conditioning system and control
buttons for the work lights, boom suspension and
radio control.
Air conditioning
The commands of the cab air conditioning system are
present in the upper part of the commands page.
Press button 1 to activate or deactivate the air
conditioning.
1
2
3
4