Magni RTH 4.18, Руководство по эксплуатации и обслуживанию, Страница: 124 / 127

124 REFERENCE INFORMATION
APPROVED EQUIPMENT
Using equipment that is not approved for use on the
vehicle can cause accidents or even death.
Before installing equipment on the vehicle, make
sure it has been approved by Magni Telescopic
Handlers s.r.l., and that the corresponding load
charts are present in the vehicle management
software.
The code of the equipment manufactured by Magni
Telescopic Handlers s.r.l. is stamped on its
identification plate. To establish whether equipment
is approved, contact the dealer or the Customer
Service directly.
Some equipment produced by other manufacturers
can be adapted for fitting on the vehicles described in
this Manual. Contact your dealer to know if your
equipment can be adapted for assembly on your
vehicle.
If the equipment is suitable and before proceeding,
the equipment and the vehicle must be sent to the
dealer for the required modifications and tests. At the
end of the procedure a certificate of conformity will be
issued.
It is forbidden to use equipment not accompanied by
the certificate of conformity. It is also forbidden to
use equipment on your vehicle if the certificate of
conformity does not confirm the compatibility.