Magnetic Autocontrol MPS-122, Руководство по эксплуатации

Страница: 40 / 90

Swing Door MPS-122
Mechanical settings and final installation
40 5817,0011EN / Version 04
7.1.2 Adjusting the mechanical end stops
Right end stop 1. Turn outer tube to the right until the stop screw touches the
right end stop.
2. Loosen the screw of the right end stop and move it until the
end stop is about 92° to the right of the desired home position.
Fig. 16: Adjusting the right end stop
3. Tighten the bolt firmly.
Left end stop 4. Turn outer tube to the left until the stop screw touches the left
end stop.
5. Loosen the screw of the left end stop and move it until the end
stop is about 92° to the left of the desired home position.
Fig. 17: Adjusting the left end stop
6. Tighten the bolt firmly.
7. Taking the swing door into operation. → See page 44, chapter
8. Check during commissioning if targeting the positions works
correctly. If the positions are not targeted correctly, adjust the
end stops again.
8. Install the O-ring with cover disc.