Magnetic Autocontrol MHTM MicroDrive, Руководство по эксплуатации

Страница: 152 / 196

Barrier MHTM
TM
MicroDrive
Start-up and operation
152 5815,5001US / Version 02.66
11.2 Commissioning
Check before
to initial start-up The following inspections must be performed prior to initial start-up:
 Check electrical connections.
 Check barrier arm position.
 Check balancing springs in the lever system and adjust if
required.
Inspection during the
first start-up The following inspections must be performed prior to first start-up:

Check program mode.

See page 112, chapter 10.7.
 Check parameterisation in connection with wiring.
 Testing and setting the operating frequency of the induction
loops.

See page 144, chapter 10.15.1.
 Check the function of the barrier, induction loops, safety light
barriers and the signalling devices.
11.3 Switching on and off the barrier
NOTICE!
NOTICE!
A too early mains voltage power up after a shut
down can result in damage of the equipment!
Therefore:
– Wait for at least 10 seconds after shutting off
the mains voltage before you switch the mains
voltage on again.
Fig. 53: Switching on and off the barrier
1 Service socket (WARNING: Service socket is live, also when mains
switch is switched off.)
2 Double pole mains switch