Magnetic Autocontrol MHTM MicroDrive, Руководство по эксплуатации

Страница: 136 / 196

Barrier MHTM
TM
MicroDrive
Parameterising control unit
136 5815,5001US / Version 02.66
10.10.10 Closure by light barrier
Operating view

Main menu

Settings

Closure by light barrier (light barr.)
Parameters Description
Closure by light barrier Use this parameter to select the closing behaviour for barriers with only one
safety light barrier installed.
If a safety loop is installed, the barrier closes only after the first vehicle has
driven through in the automatic program modes 5 to 8. If only a safety light
barrier is installed, the barrier will not close automatically after the first vehicle
has driven through in the automatic program modes 5 to 8.
Options
 Inactive
In program modes 5 and 6, the barrier only closes if either a closing signal
is applied or the hold-open time has passed. In program modes 7 and 8, the
barrier only closes when a closing signal is applied.
 Active
In program modes 5 to 8, the barrier closes at once when a vehicle drives
through the safety light barrier.
Factory setting
 Inactive
Table 49: Menu "Closure by light barrier"
10.10.11 Master/Slave
Operating view

Main Menu

Settings

Master/Slave
Parameters Description
Master/Slave
Activate and deactivate "Parallel operation" function. By activating the
master/slave function, the corresponding inputs and outputs are automatically
converted.

For information on parallel operation, see separate instructions.
Options
 inactive
 active
Factory setting
 inactive
Table 50: Menu “Master/Slave”