PREPARATION OF THE DEVICE
Replace the screw and washer centering the two
holes with the pins. Tighten the screw all the
way, eliminating any slack in the column and
give it another quarter turn, always taking care to
the direction of orientation.
Return the structure to the upright position,
check the correct orientation between the base
and the column and check column rotation.
Remove the optical box and fit it in from the top
of the box in the housing on the slider of the
column taking care to fit it all the way in. Fasten
the optical box to the slider using the screws
supplied, to be assembled on the bottom of the
box, as shown by the arrows in the figure.
Remove the visor from the carton, screw it onto
the support and tighten, using the hole in the
visor.
