MHR Radio Controller Instruction Manual
June 2017
Page 14 of 58
Figure 04: MHR with Con1 and Con2 connectors
Figure 05: MHR Side View
2.3 INSTALLATION
1. Determine the location of your antenna from Figures 01-03 (antenna is designated with
red arrow).
Be sure to mount the receiver antenna in direct line-of-sight of the
operator and free from all obstructions.
NOTE: When installing the antenna, it should only be tightened by fingers. No tools should be
used to tighten the antenna as this will lead to over torqueing of the antenna. A wicking grade
thread locker (equivalent to Loctite 290) can be used to ensure the antenna will not come loose.
2. Do not mount the receiver near high levels of electric noise, such as an unshielded
variable frequency drive, as it may cause minor interference.
3. Allow adequate room for mounting the receiver. Make sure to allow a minimum of 5”
between the connector and nearest surface to allow for cable harness connections.
4. For best reception, and to help protect connectors from moisture and water damage,
mount the receiver in an upright position. Mount with back flush against a flat surface to
protect vents from spray.
5. If obstructions can’t be cleared, or the unit must be mounted inside a metal enclosure, the
remote antenna should be used (see Figure 01).
6. Do not enclose the antenna in steel. For best reception, keep all metal objects away
from the antenna.
Consult the factory for more information regarding your
application.
7. When mounting the receiver, the unit should be torqued no more than 10-12 in-lbs.
8. Ensure adequate voltage transient suppression is provided at the power input.
Содержание MHR
