IMPULSE•G+/VG+ Series 4 Technical Manual
November 2022
Page 181
5.8.4 Copy Function
Table 5-110: Copy Function Parameter Settings
The keypad has parameter COPY capabilities via built-in non-volatile memory. The keypad can READ all of the
parameters in the VFD and store them for later, and then WRITE them to a VFD with the same model number and
firmware version. In order to read the parameter values and store them into the keypad, select O04-02 = 1 (Enabled).
If O04-02 = 0, you will get the following error:
After setting O04-02 = 1 (Enabled), it is possible to store parameter values in the keypad by setting O04-01 = 1
(INV
OP READ). A successful READ of the parameter values will display:
If an error is displayed, press any key to cancel the error display and return to parameter O04-01. Error displays
and their meanings are covered in Chapter 6.5: Copy Function. To COPY the parameter values into a VFD, set
O04-01 = 2 (OP
INV WRITE). During the writing of the parameter values into the VFD, the keypad will display:
Parameter
Display
Function
Range
Default
O04-01
Copy Function Sel
Copy parameters to/from keypad
0–3
0
0 COPY SELECT
1 INV
OP READ
VFD
Keypad
2 OP
INV WRITE
Keypad
VFD
3 OP
↔
INV VERIFY
Keypad
↔
VFD
O04-02
Read Allowable
Enables/disables copy function
0, 1
1
0 Disabled
1 Enabled
O04-07
ChrgCircMaintSet
Maintenance Monitor for the soft charge
bypass relay. See U04-06 to check when
the bypass relay may need to be replaced.
0–150%
0
Содержание Impulse G+ series 4
