![background image](http://html.mh-extra.com/html/magnetek/g-series/g-series_technical-manual_693888051.webp)
Motorized Cable Reel Technical Manual
September 2021
6.3.4 Disassembling the air gap slip ring assembly
The slip ring assembly must be disassembled before connecting the cable, depending on the delivery
condition of the device.
1. Disassemble the covering hood on the cable enclosure (
|
14, page 76, item 3.5).
2. Number the wires of the permanently routed cable on the brush holders and disconnect them.
3. Disassemble the hexagon nuts, flat washers and spring rings on the threaded rods (brush holder).
4. Loosen the clamping screws on the brush holders.
5. Disassemble the brush holder phase.
6. Disassemble the long insulating pipe (brush holder).
7. Disassemble the brush holder PE.
8. Disassemble the short insulating pipe (brush holder).
9. Disassemble the brass pipe.
10. Disassemble the threaded rod (brush holder).
11. Disassemble the hexagon nuts, flat washers and spring rings on the threaded rods (slip ring).
12. Disassemble the short insulating pipe (slip ring).
13. Number the wire of the reeling cable on the slip ring and disconnect it.
14. Disassemble the slip ring phases.
15. Repeat action instructions 12 and 14 four times.
16. Disassemble the long insulating pipes (slip ring).
17. Number the wire of the reeling cable on the slip ring PE and disconnect it.
18. Disassemble the PE of the slip rings.
INFORMATION
►
See Figure 22 on page 35.