![background image](http://html.mh-extra.com/html/magnetek/g-series/g-series_technical-manual_693888038.webp)
Motorized Cable Reel Technical Manual
September 2021
3
The covering hood on the cable enclosure has been disassembled (
|
14.1, page 76, item 3.5).
1. Loosen the screws of the strain relief clamp (
|
2. Route the reeling cable along the reel rim onto the reel body.
3. Route the reeling cable through the strain relief clamp through the cable screw connection into the
hollow shaft.
4. Loosen the cable screw connection on the hollow shaft.
5. Route the reeling cable through the hollow shaft into the cable enclosure.
6. Slide the insulating pipes over the threaded rods (slip ring).
7. Install the slip ring PE.
8. Strip the cable end to the required connection length.
9. Strip the wire and fit it with a ring cable lug.
10. Connect the wire PE of the reeling cable with a Filister screw and a disc to the slip ring PE.
11. Slide the insulating disc over the insulating pipes (slip ring).
12. Install the slip ring phase at a 120-degree offset (
|
13. Strip the wire phases and fit them with ring cable lugs.
14. Connect the wire phase of the reeling cable with a Filister screw and disc to the slip ring phase.
15. Repeat action instructions 11 to 14 three times.
The slip ring phase and insulating discs have been installed.
The wire phases of the reeling cable are connected to the slip rings.
16. Slide the insulating disc, the insulating end disc and the insulating disc over the threaded rods (slip
ring).
17. Install the hexagon nuts, flat washers and spring rings on the threaded rods (slip ring).
18. Install the threaded rod (brush holder).
19. Slide the brass pipes over the threaded rod [brush holder].
20. Install the brush holder PE and center it (
|
21. Slide the short insulating pipe over the threaded rod (brush holder).
22. Install the brush holder phase.
INFORMATION
►
Connect the wires of the reeling cable to the slip rings so they are offset by
120 degrees (
|
1 Slip ring
2 Wire connection
Figure 25 Wire connections on the slip rings