![background image](http://html.mh-extra.com/html/magnetek/g-series/g-series_technical-manual_693888036.webp)
Motorized Cable Reel Technical Manual
September 2021
6.2 Spiral version
The slip ring assembly must be dismantled before connecting the cable, depending on the delivery
condition of the device.
6.2.1 Dismantling the blocked slip ring assembly
INFORMATION
►
See Figure 21 on page 34.
1. Dismantle the covering hood (
|
14.1, page 76) on the cable enclosure.
2. Number the wires of the permanently routed cable on the brush holders and disconnect
them.
3. Disassemble the hexagon nuts, flat washers and spring rings on the threaded rods
(brush holder).
4. Loosen the clamping screws on the brush holders.
5. Disassemble the brush holder phase.
6. Disassemble the brush holder phase insulating pipes.
7. Disassemble the brush holder PE.
8. Disassemble the brass pipe.
9. Disassemble the threaded rod (brush holder).
10. Disassemble the hexagon nuts, flat washers and spring rings on the threaded rod (slip
ring).
11. Disassemble the insulating discs.
12. Number the wire of the reeling cable on the slip ring and disconnect it.
13. Repeat action instructions 11 and 12 four times.
14. Disassemble the insulating pipes (slip ring).