Magnescale SR87, Руководство по установке

Страница: 20 / 44

8
(E)
SR87, CH33
Example 3: Other procedures for slider installation
Install according to your intended application.
Pattern 1
Th e M4 hex. socket-head cap screws must be supplied by
the customer.
Pattern 2
Installing the rubber bushing on the M4 nut enables
installation without the nut falling off .
Th
e M4 hex. socket-head cap screws must be supplied by
the customer.
Note
Because the nut position is limited by the rubber bushing,
pay careful attention to the tolerance of the slider mounting
holes.
Pattern 3
Th e M6 hex. socket-head cap screws must be supplied by
the customer.
M 4
M 4 nut
(opposite side: 8 mm)
Tightening torque
M
4 : 2.7 N·m
M 4
Rubber bushing
M 4 nut
(opposite side: 7 mm)
Tightening torque
M
4 : 2.7 N·m
Tightening torque
M
6 : 9 N·m
M 6
M 6 tap
Air purge
In the standard confi guration, an M5 tap hole for air purging is provided in the end cover section of both
scale ends. For more detailed information, please refer to the Instruction Manual (sold separately).