MagneMotion MagneMover LITE, Руководство пользователя, Страница: 99 / 382

Design Guidelines
Custom Motor Mounting
MagneMover LITE User Manual 29
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
Custom Motor Mounting
The following motor mounting guidelines are provided when designing a custom motor
mounting surface (replacing the MagneMotion leg and beam system) or custom motor mounts
(replacing the MagneMotion motor mounts) for the MagneMover LITE motors instead of
using the MagneMotion motor mounting system.
Figure 3-18: Custom Motor Mounting
1. Mount the motors to the custom motor mounts (or MagneMotion motor mounts) using
M6 screws. The motor to motor mount hardware and the motor mount to custom
motor mounting surface should be loosely attached. The motors should have a small
amount of movement relative to each other.
2. Ensure consistent spacing between the motors.
3. Ensure the top surface of all motors are coplanar to each other.
4. Install the V-braces on all guide rails using M6 x 12 mm screws and tighten fin-
ger-tight to pull the rails together.
NOTE: For systems using railless motors the V-braces are attached to the top of the
motor body. For straight motors, the V-braces are attached to both sides of
the motor. For curve motors the V-braces are only attached to the outside of
the motor.
5. Treating each motor to motor interface as a separate operation, the associated V-brace
is tightened to lock in the guide rails between both motors. As this operation is per-
formed, visual and tactile sensing of the guide rail joints is performed and based on
M6 x 12 mm Screw
V-Brace
Guide Rail
Motor Mount
Consistent Motor Gap
(M6 screw)