MagneMotion MagneMover LITE, Руководство пользователя, Страница: 332 / 382

Maintenance
Repair
48 MagneMotion
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
Figure 7-18: Install Precision Rail Vehicle on Rail
7. To adjust both eccentric bearings, refer to Adjusting Vehicle Bearings on page 7-11 .
8. Re-attach the lubricating applicator to bottom of the vehicle. See Replacing Lubricat-
ing Applicators on Vehicles on page 7-50 .
9. Return the MM LITE transport system to normal operation.
Removing Vehicles by Removing Rails
The single or dual array vehicles can be removed from the Precision Rail system by removing
a precision rail section.
1. Stop all motion on the section of the MagneMover LITE transport system where the
vehicle will be removed.
2. Remove a small section of the precision rail by removing the M5 screws securing it to
the spine plates.
3. Move the vehicle to be removed to the open section and lift it out.
NOTE: Once vehicles are removed from the transport system they must be stored in
their original packaging to protect the vehicle and to minimize any safety
risks.
4. Replace the removed rail section.
A. Position the rail over the edge of the spine plates, aligning the letters engraved
on the end of each rail segment and the mounting holes in the rail over the
spine plate holes.
B. Secure the rail to the corresponding spine plates using M5 SHC screws, tighten
each screw to 1.8 N-m [16 in-lb], using the sequence shown in
Figure , Align
and Secure Rails to Spine Plates , on page 5-50 .
5. Return the MM LITE transport system to normal operation.