MagneMotion MagneMover LITE, Руководство пользователя, Страница: 244 / 382

Installation
Option Installation
58 MagneMotion
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
Install the Pneumatic Controls
The pneumatic fittings on the Precision Locator’s cylinder should be installed before the loca-
tor is mounted on the stand to allow ease of access (refer to
Install the Precision Locators on
the Stands ).
Figure 5-41: Precision Locator Pneumatic Connections
1. Install the pneumatic valve that will control the Precision Locator. This procedure
assume the use of a 5/2 valve as described in
Precision Locator Installation on
page 3-43 .
A. Connect the pneumatic valve control lines to the Host Controller’s Digital I/O.
B. Connect the valve’s pneumatic input to the facility’s compressed air line.
C. Connect the pneumatic valve’s #2 output to Open on the Precision Locator’s
pneumatic cylinder.
D. Connect the pneumatic valve’s #4 output to Closed on the Precision Locator’s
pneumatic cylinder.
E. Connect the pneumatic valve’s exhaust #3 to a flow control valve. The flow
control valve should be adjusted to limit the pinning time to 100 ms or greater.
Please note that all life estimates are based on a pinning time of at least
100 ms.
F. Connect the pneumatic valve’s exhaust #5 to a muffler.
2. If using the optional cylinder position sensors:
• If installing user-supplied sensors, install them into position and secure as
directed by the manufacturer.
Open Locator
Close Locator
(Extend Cylinder)
(Retract Cylinder)