Fig. 1
Wooden Windows
Air Directional Louvers
throughout the room as needed. Pivot horizontal
Move the Levers from side to side until the desired
Levers
Air Direction
INSTALLATION INSTRUCTIONS
23 to 36 inches (See Fig.1).
Lower sash must open sufficiently to allow a clear vertical
opening of following size (see Table 1).Side louvers and the
rear of the AC must have clear air space to allow enough
airflow through the condenser for heat removal. The rear of
the unit must be outdoors, not inside a building or garage.
NOTE:
Save
Carton
and these
Installation Instructions
for future reference. The carton is the best way to store unit
during winter or when not in use.
3 4 (or 1
)
Screws
(7)
2 Lock Frame
(2)
Sash Lock
(1)
Mounting Hardware
TOOLS NEEDED:
Phillips Screw Driver
Drill(If pilot holes are needed)
CAUTION:
When handling unit, be careful to avoid cuts from
sharp metal edges and aluminum fins on front and rear coils.
Top Rail Hardware
3 8 Screws
(4)
Top Rail
(1)
on the unit (For <10000Btu/h models only).
Tool Needed:
Phillips Screwdriver
A: Remove the air conditioner from the carton and place
on a flat surface.
B:
Remove top rail from the rear of the packaging material
as shown in Fig. A.
10
NOTE:
The top rail hardware and the following Fig.A,
than 10000Btu/h.
Packaging
Fig.A
Top Rail
Model
Size
5000~8000Btu/h
10000~12000Btu/h
14 (35.6cm)
15-1/2 (39.4cm)
Table 1
The louvers will allow you to direct the air flow UP
or DOWN (on some models) and Left or Right
louvers until they are in the preferred direction.
LEFT/RIGHT direction is obtained.
Your air conditioner is designed to be installed in standard double hung windows with opening widths
of
Fig.B and Fig.C are not applicable to units
more
Before installing unit, the top rail must be attached
or DOWN(only on some models) and Left or Right
15.5''min
LEFT/RIGHT direction is obtained.
(39.4cm)
58.4cm to 91.4cm
OFFSET
EXTERIOR
WALL
INNER
WINDOW SILL
INTERIOR
WALL
Содержание MG-06CR
Страница 19: ......
