50
If the unit does not perform properly when operated as instructed in this manual, check the unit, consulting the
following checklist.
Troubleshooting
Problem
Solution
No power
- Check if the AC cord is properly connected.
- Unplug the AC cord once, and wait for 5-10 seconds and then plug it in again.
No sound or picture
- Check if the connected TV is turned on.
- Check if the connections are made securely and correctly.
- Check whether the connected TV or other device supports HDCP. (This unit will not
output a video signal unless the other device supports HDCP.)
- Check whether the output format of this unit (HDMI FORMAT) matches the
supported input format of other connected device.
No audio / video signal on the
display device via HDMI cable
- If the unit is connected to the unauthorized display device with an HDMI cable, the
audio / video signal may not be output.
- Perform an HDMI cable hotplug, wherein you disconnect the HDMI cable from the TV
and this unit and then reconnect it to both the devices while they are powered on.
- Ensure that your HDMI cable is certified.
Distorted picture
- Sometimes a small amount of picture distortion may appear.
This is not a malfunction.
- Connect this unit directly to the TV. If the audio / video cables are connected to a
VCR, pictures may be distorted due to the copy right protection system.
Completely distorted picture
or black / white picture with
BD / DVD
- Make sure the disc is compatible with this unit.
No sound or distorted sound
- Adjust the volume.
- Check if speakers are connected correctly.
- Check the HDMI connections.
- Check the settings in “Audio” menu.
Picture freezes momentarily
during playback
- Check the disc for fingerprints / scratches and clean with a soft cloth wiping from
center to edge.
- Clean the disc.
Disc cannot be played back
- Clean the disc.
- Ensure the disc label is facing up.
- Check if the disc is defective by trying another disc.
- Cancel the ratings control or change the control level.
- Insert a correct disc that can be played back on this unit.
SD Memory Card cannot be
read
- The format of the card does not match that accepted by this unit or the card is not
compatible.
No return to start-up screen
when disc is removed
- Reset this unit by turning it off, then on again.
The unit does not respond to
the remote control
- Aim the remote control directly at infrared sensor window on the front panel.
- Reduce the distance to infrared sensor window.
- Replace the batteries in the remote control.
- Re-insert the batteries with their polarities (+ / - signs) as indicated.
Buttons do not work or the
unit stops responding
- To completely reset the unit, press and hold
[
on the front panel
for 10 seconds to shut down the unit or unplug the AC cord from the AC outlet for
5-10 seconds.
The unit does not respond to
some operating commands
during playback
- Operations may not be permitted by the disc.
Refer to the instructions of the disc.
The unit cannot read BD /
DVD/ CD
- Condensation? (Let sit 1 or 2 hours)
- You are attempting to playback a disc other than one with one of the Logos on
- Wipe the dirt off the disc or replace the disc.
