These operations are accessible by remote control.
Some may also be accessible by the main unit's control panel.
Initial setup
This section will guide you through the unit’s Initial setting which
includes selecting a language for your on-screen menu, country,
location and Autoprogram, which automatically scans and
memorizes viewable channels. You can also set the network
connection in this setting.
Before you begin:
Make sure the unit is connected to an antenna or cable.
1
After making all the necessary connections, press
B
to turn
on the unit.
●
It may take a few moments to turn on the unit for the first
time.
●
Initial setup
menu appears automatically after the unit is
turned on.
2
Use
H
I
to select the on-screen language, Voice guide,
country, TV placement and location in the middle of the TV
screen, then press
OK
.
●
You must set
Home
in location setting. Otherwise,
Picture
and
Sound
settings you adjusted will not be memorized
after the unit goes into standby mode.
3
Use
J
K
to select
Skip
or
Next
on network setup screen.
4
Use
H
I
to select
Wireless
or
Wired
, then press
OK
.
1234
7
5
6
Skip
Wired
Wireless
Installation
Select your connection type.
This TV can be connected to your
home network.
Wireless
If you have a wireless router, select
Wireless
to
connect to the internet.
Wired
If you connect with an Ethernet cable, select
Wired
to connect to the internet.
●
If you have a router with easy connect function, select
Wireless
and use
J
K
to select
Simple Connect
, then press
OK
.
5
Follow the on-screen instructions to complete the installation.
●
When you select
On
in the selection screen for
Software
update notification
, A message will appear later if there is
the latest software on the network server.
6
Use
H
I
to select the signal type.
●
If the TV is connected to a cable or satellite set-top box,
select the 2nd one and skip to step
8
.
1234
7
56
Installation
Set-top box
Select "Set-top box" to set up a TV
signal from a cable TV box
or satellite TV receiver.
Antenna
Select "Antenna" to set up a TV
signal from a cable TV wall jack or
a standard TV antenna.
7
Use
H
I
to select
Antenna
for TV channels or
Cable
for CATV
channels, then press
OK
.
1234
7
56
Installation
Skip
Cable
Antenna
Now select either Antenna or
Cable, using up/down key of the
remote control. Once you have
made your selection, press the OK
button to proceed.
Make sure that you have attached
your antenna or cable signal into
the jack on the back of your TV
labeled "ANTENNA IN".
–
When
Antenna
is selected, the TV detects antenna
signals. It searches for DTV and analog TV channels
available in your area.
–
When
Cable
is selected, the TV detects signals supplied
by cable. It searches for DTV, analog TV and cable
channels available in your area.
●
Auto programming will begin.
0
0
1234
7
56
Installation
Stop
Total progress:
Analog channels found:
Digital channels found:
Please wait until you see the Auto
Programming complete message.
Digital channels will take longer
than Analog to find and program.
Auto programming may take more
than 20 minutes to complete.
System searching. Please wait…
19
.
English
Continued on next page.
