Magmate 180P, Руководство по эксплуатации

Страница: 20 / 24

20
7.0 Operating Controls and Contents
1
Wire Inch Switch
2 Pressure Adjusting Knob
3
Flexible Conduit
4 Torch Connector
5
Conduit
6
Roller
7 Posititive Terminal
8
Negative Terminal
9 Spool Holder
10 Gas Inlet
11 Wire speed (voltage control) 14–26 V
12
Fully adjustable current setting from 20–180 A
13 Fully adjustable, infinitely controllable inductance
14
High/low speed adjustment. Extends the wire feed speed
capability for larger diameter wires
7.1 Machine Setup
Connect the MIG welding torch (supplied) 1
to the machine by connecting the backend
to the universal fitting on the machine.
Ensure that the torch is screwed in tight.
The MagMate 180P is designed for D200
2
(5 kg) spools maximum. Fit the spool onto
the spool holder and ensure that the
locating nut is replaced and tightened.
Feed the wire through the system by utilising
3
the Wire Inch Switch. An inbuilt safety
override will ensure that the wire feed speed
is not excessive.
Adjust the pressure adjusting knob to ensure
4
that the wire is fed evenly. Over tightening
the adjusting knob will cause undue strain on
the wire feed motor.
Select the wire speed selector switch to high
5
speed for 0.6 and 0.8 mm wires and at low
speed for 0.9 and 1.0 mm wires.
If a solid gas-assisted wire is used, connect
6
the gas hose to the gas inlet connection
situated at the back of the machine.
Using the table supplied in this manual, adjust
7
the voltage and amperage depending on the
diameter of the wire.
Improved arc characteristics can be obtained
by changing the infinite variable inductance.
If welding certain grades of flux-cored wires
that require the polarity of the machine to
be changed, this can be achieved by changing
the wire positions on the positive/negative
terminals.
WARNING:
When changing the polarity on
the machine, it needs to switched off and the
primary cable unplugged from the mains socket.
For solid wires, the wires and terminals are
clearly marked (red on positive terminal).
ILLUSTRA
TION
1
2
3
5
4
6
7
8 9 10
13
14
12
11