DISASSEMBLY & RE-ASSEMBLY
• Lift radiant plate up & out of left slot (see B) and remove by sliding it out of right slot
(see C).
• Remove burner retainer pin (see B) & remove burner. Inspect burner, remove any
obstructions. CAUTION: WHEN REPLACING BURNER, CUT SLOTS IN BURNER MUST
FACE DOWN.
• To remove liner from outer shell you must disconnect the electrode wire (see D).
First remove the two screws on valve chamber (see D) and remove the cover plate.
Gently pull wire off connector (see D). It is not necessary to remove electrode from
liner.
• Remove Lid and liner by removing hinge screws and lock nuts with 3/16” hex key
wrench (supplied) and 1/2” wrench or pliers. CAUTION: LOCK NUTS MUST BE
INSTALLED WITH LOCKING INDENT MARKS SHOWING (see E). IMPROPER
INSTALLATION WILL DAMAGE THE HINGE SCREW AND LOCK NUT.
• Lift liner out of outer shell by lifting up on liner lip on back side of liner
(see F). When replacing liner, be sure top lip of liner installs over top edge of outer
shell (start with corners of lip and work in).
• Clean as indicated in Maintenance (page 6).
• To re-assemble, reverse the procedure above.
ELECTRODE SPARK ADJUSTMENT
CAUTION: Spark can cause small shock. Do not leave fingers on
or near electrode wire while engaging igniter.
• Electrode wire should be approximately 1/8” from gas exit
hole in burner. Carefully adjust wire if required.
A
Locking
Indents
E
Outer Shell
Liner
Liner Lip
F
Right
side
slot
C
Electrode
Retaining pin
B
Left
side
slot
Radiant Plate
Disconnect
wire
D
Screws
Battery
5
