Magio MG-965, Инструкция по эксплуатации

Страница: 23 / 25

23
Hand pump dispensing can be used even if the appliance is not connected
to the power. However, the thermo pot will not be able to keep the set
temperature for a long time in case it is not connected to the newtwork.
Note
The unlock button is a security measure to prevent accidental spillage of
hot water from the appliance.
Note
There are thre types of water dispense:
1.Automatic pump dispenser.
- Press «Unlock» button (page 20) on the control panel.
- The unlock indicator will light up.
- Place the cup under the water spout (4).
- Press the «Water dispense» button (page 20). The appliance will start water
dispensing.
2. Hand pump dispenser.
- On the upper lid (10), switch the hand pump lock (8) to the “unlock” position.
- Then push the hand pump (7) to pour water.
- Let the hand pump (7) turn to its default position and repeat action if need more
water.
2. Cup trigger dispenser.
- Press «Unlock» button (page 20) on the control panel.
- The unlock indicator will light up.
- Holding the cup under the water spout (4), press it on the cup trigger dispenser
(3) by a cup.
- The thermo pot will automatically dispense water from the spout till you are
pressing the cup trigger dispenser.
- Press the «Re-boiling» button (page 20) to boil water again.
- The green light indicator goes out and the red boiling indicator will light up.
- After re-boiling ends, the keep warm indicator will light up.
Attention! If the «Water dispense» button will not be pressed within 10 seconds
after pressing the «Unlock» button, the device will automatically lock again.
Attention! If the cup trigger dispenser button will not be pressed within 10
seconds after pressing the «Unlock» button, the device will automatically lock
again.
The automatic pump dispenser function will not work if the device is not
connected to the network.
The cup trigger dispenser function will not work if the device is not connected
to the network.
Attention! If pressing the «Re-boiling» button does not work (does not start the
boiling process), it means that water is boiled and hot enough and no need to
warm it again.
Re-boil function
EN