Magicar FAI-8100, Руководство пользователя, Страница: 10 / 12

10
All sensors such as door, hood, trunk and shock except for ignition will be activated 40 seconds after the system is armed.
Auto Re-Arm
Steps to default Auto Re-Arm enable:
Take the same procedure as above.
If Auto Re-Arm Enabled, the system will be automatically armed 30 seconds after the system is disarmed.
Anti-Hijacking Mode
Steps to default Anti-Hijacking enable:
Take the same procedure as above.
It is not a user option to program. Consult with your installation center in advance.
Important : If the users want to use Anti-Hijacking Mode, the installer shall connect Starter Kill relay.
Unless the starter kill is connected, the start motor will shut down when Anti-Hijacking Mode is operated.
It is a convenient feature to use when your vehicle is just stolen.
Press button (3) once when the engine is on.
LED starts to flash rapidly 15 seconds, then the parking lights start to flash and siren chirp in one cycle. But continue to
sound and flash unless the car key is off. Then door will be locked, Starker Kill on and armed.
Press button (1) once to quit Anti-Hijacking mode.
Car Type
Steps to default Car Type as Automatic or Manual:
Take the same procedure as above.
It is not a user option to program. Consult with your installation center.
Engine Start Mode
Steps to default Engine Start Mode as Alternator or Tach:
Take the same procedure as above.
It is not a user option to program. Consult with your installation center.
If Tach Sensing (RPM) programmed,
a) Perform the tach learning at first time before remote start.
b) Make sure the Tach wire(Green) of the alarm system shall be connected to the negative of the coil as shown in
wiring diagram.
Crank Time
Steps to default Crank Time as 0.6, 0.8 or 1 second:
Take the same procedure as above.
It is not a user option to program. Consult with your installation center.
Normally, the old and diesel vehicles need longer crank time to start engine.
However, if the engine doesn’t start smoothly, please default the crank time longer.
Start Running Time
Steps to default Start Running Time as 10 minutes or 20 minutes:
Take the same procedure as above.
Depending on the defaulted engine running time, the engine will run 10 or 20 minutes and shut down automatically.
24-Hour Engine Start Mode
Steps to default 24-Hour Engine Start Mode as 3 hours, 6 hours or off:
Take the same procedure as above.
It is the most convenient feature to use in the cold winter season.
a) Press button (1) and (3) once at the same time to activate 24-Hour Engine Start Mode, then siren will chirp once, lights
flash once to confirm.
www.shieldtechsecurity.com