Basic operation
Resilience D Installation guide. © 2016, all rights reserved
P a g e
|
26
Turbo mode additional information –
-
Counting is performed only when the unit is ON.
-
During the first 5 seconds in Turbo screen, additional presses on the Turbo button increases the
timer in increments of 12 hours with each press: 12, 24, 48, 72 or 0 hours.
-
Cancelling the Turbo option reverts back to the previous output selection.
-
Pressing the Mode button while Turbo is on, allows changing between screens, while the Turbo lamp
continues to blink.
-
If Turbo mode is activated, the numerical display in the main screen shows the turbo timer and not
the word ON.
-
Power rises to 100%. In case of low salinity, the reading is similar to low salinity condition (i.e. the
maximum output might be 60% so the blinking bar will show 100% setting and the solid output bar
will show 60%).
POOL COVER FUNCTION
The unique pool cover function enables the chlorinator to reduce the chlorine output while the pool is covered.
When the pool cover is over the pool the chlorinator will automatically reduce its chlorine output to 20% of the
maximum level and a "AUX MODE" message will appear on the numerical display.
Pressing and buttons while the system is in pool cover mode enables to permanently set new output values
to the unit while the pool is covered (e.g. the default setting is 20% total, but when the pools is covered you may
change the default setting to be 40%. The setting will remain 40% for the next pool covering occurrences). In order to
activate this function properly, make sure the control box is getting a dry contact from the pool cover control when
the pool is covered.
