Magellan ProMark 3, Руководство по началу работы

Страница: 38 / 82

32
English
Configuring a Base
It is assumed that the ProMark3 RTK base has been set up as
explained in
RTK Setup on page 11 . If you want to use the Bar
method to initialize the rover, don’t forget the kinematic bar
between the antenna and the tribrach.
1. Tap on the
Equip
tab.
2. Tap the on the
Instrument
button.
3. Select
ProMark3 Magellan Base
and tap
OK
.
4. Tap on the
Configure Base
button, define the antenna
height and type as well as the elevation mask.
If you intend to log base raw data, check on the
Data
Recording
option, set the recording interval in seconds,
define the media where to store the data (SD Card or
Internal memory) and enter a Unit ID. Reminder: This
parameter is used as header in raw data filenames.
5. Tap
OK
to enter all these settings. FAST Survey then asks
you to enter the position of the base and then the refer-
ence station ID.
6. When base configuration is complete, FAST Survey asks
you to save the base settings in a ref file (<job_name.ref).
The ProMark3 RTK will then run as a base until you exit
FAST Survey.
Configuring a Rover
It is assumed that the ProMark3 RTK rover has been set up as
explained in
RTK Setup on page 11 .
1. Tap on the
Equip
tab.
2. Tap the on the
Instrument
button.
3. Select
ProMark3 Magellan Rover
and tap
OK
.
4. Tap on the
Rover Settings
button, define the antenna
height and type as well as the elevation mask. Indicate the
type of position solution that is expected from the rover
(“Float” or “Fixed” status).