Magellan MobileMapper MobileMapper 6, Руководство по началу работы

Страница: 15 / 28

English
7
First-Time Use
Inserting Fresh
Batteries
• Turn the finger screw counter-clockwise a quarter turn and
pull the battery door open. The battery door stays attached
to the receiver via a short black strap.
• Insert two AA batteries head-to-tail. Observe the polarity
for each battery by reading the “+” and “-” signs
embossed in the bottom of the battery compartment.
• Put the battery door back into place by first inserting the
two clips, located on either side of the strap, into the
receiver case. Then push the door against the case and
rotate the finger screw clockwise by one-quarter turn to
secure the door.
Turning the
Receiver On
• Press the Power button briefly. (This button is located at
the top and on the right side of the receiver).
After a few seconds, the Magellan Professional logo will
appear on the screen, followed by the Windows Mobile
splash screen. Then MobileMapper 6 will emit a beep
suggesting that you tap anywhere on the screen (
Tap the
screen to set up your Windows Mobile-based device
) to initiate
the setup sequence described below:
1. Screen alignment: Tap the target firmly and accurately
at each location on the screen. The target will continue
to move until the screen is aligned.
2. Stylus: Run this step to learn how to perform single-tap
and tap-and-hold actions with the stylus.
3. Date & Time: Choose your time zone and enter your
local date and time parameters.
4. Password: You can protect your data by requiring a
password when the device is turned on. A password
also helps to protect networks that you access. Tap
Next
to set up a password.