Magellan MobileMapper CX - Hiking GPS Receiver, Руководство по началу работы

Страница: 73 / 86

English
65
Outputting the NMEA Message On USB
The USB port must be configured to emulate a serial port. Fol-
low the instructions in
Setting the Mini-USB Port (I/O Module)
on page 5 to do this. Then:
- Tap , then
Programs>GPS Utilities>GPS Ports Configura-
tion
.
- In the GPS Auxiliary Output pane, check on the
Enable
Messages
option and then select “COM6” in the
Port
field.
- Tap
Configure Port
to configure the selected port. Enter its
baud rate, number of start and stop bits and set its parity
and flow control parameters.
- Tap
OK
. MobileMapper CX will now deliver the NMEA mes-
sage you have defined on its USB port.
Outputting NMEA Data on Virtual Port COM2
From the moment a non-empty NMEA message is defined (see
page 64 , MobileMapper CX will output this message on its vir-
tual port (COM2), independently of whether the message is
enabled on the auxiliary output port or not.
The COM2 settings can be displayed by tapping
Port Status
.
These settings cannot be changed:
• Baud rate: 57600 Bd
• Data bits: 8 data
• Parity: None
• Stop bit: 1
• Flow control: None.